Auto Code Readers

Isuzu Automatic Transmission - Auto Repair Codes

Scan Tool for Codes and Live Data for your Isuzu Transmission from $149.95

The information below may apply to Isuzu Gemini and many other models

Step 4
Isuzu Trans Code Reading
Connector Diagram
connector location
Auto Repair Manual - How to read codes (No Special Tools Needed)
IMPORTANT:If after you turn the ignition ON does not show that it is outputtting any data there are either NO fault codes OR the vehicle has not been put into diagnostics mode correctly. To test the connection generate a fault code by disconnecting the airflow meter or throttle position sensor, crank or run the engine and re-run the Test.
1 Drive the vehicle until transmission reaches operating temperature.
2 Stop the vehicle, place in park, or neutral and turn ignition OFF.
3 Link terminals with your own wire link, (Click here for details) , as shown in the diagram.
4 Turn ignition ON. Read codes on flashing transmission light.
5 Read codes as described in the Code Format Description below.
6 Press the continue button to enter the code numbers and get the code description.
Code Format Diagram
Code Format Description
Each code is made up of two series of flashes.
The first series indicates the 'tens' digit.
The second series indicates the 'ones' digit.
A long pause separates each code.
A shorter pause separates the 'tens' and 'ones'.
Code Format Diagram shows code No. 32.
To move to the next screen click on the Continue button
 Continue > 

Note on Example Model(s): Isuzu Gemini
The example model(s) shown, Isuzu Gemini for this auto repair service are only an indication to help you. There may be many other models that apply to this connector. Click above link to see the complete vehicle coverage list.



< Back
All content copyright Rennacs Limited, 2009. All products names mentioned herein should be considered registered trademarks of their respective owners.
For comments and feedback please email comments@rennacs.com

Disclaimer