Auto Code Readers

Toyota Engines - Auto Repair Codes

Scan Tool for Codes and Live Data for your Toyota Engine from $699 USD

The information below may apply to Toyota Hilux Surf, Sienna and many other models

Step 5
Toyota EFI Code Reading
Connector Diagram
Connector Location
Auto Repair Manual - How to read codes (No Special Tools Needed)
1 Turn the ignition OFF.
2 Connect terminals TE2 and E1 with your own wire link, (Click here for details) .
3 Drive the vehicle to attempt to simulate fault conditions.
4 If the Check Engine Light (CEL) comes on return to the workshop.
5 Connect TE1 and E1 with your own wire link, (Click here for details) .
6 Turn ingition ON, the Check Engine Light (CEL) should be flashing.
7 Read codes as described in the Code Format Description below.
8 Press the continue button to enter the code numbers and get the code description.
Code Format Diagram
Code Format Description
Each code is made up of two series of flashes.
The first series indicates the 'tens' digit.
The second series indicates the 'ones' digit.
A 2.5 second pause separates each code.
A system pass code is indicated by very short repeating flashes.
A 1.5 second pause separates the 'tens' and 'ones'. If no 1.5 second pause is found, code is single digit.
Code Format Diagram shows code No. 32.
To move to the next screen click on the Continue button
 Continue > 

Note on Example Model(s): Toyota Hilux Surf, Sienna
The example model(s) shown, Toyota Hilux Surf, Sienna for this auto repair service are only an indication to help you. There may be many other models that apply to this connector. Click above link to see the complete vehicle coverage list.



< Back
All content copyright Rennacs Limited, 2009. All products names mentioned herein should be considered registered trademarks of their respective owners.
For comments and feedback please email comments@rennacs.com

Disclaimer