If there are any present codes existing, the power light will flash ON-OFF several times when the ignition is switched on. If the power light "proves out" normally, then there are no present faults.
1 If possible, drive the vehicle until transmission reaches operating temperature.
2 Stop vehicle, place in park and turn the ignition OFF. Apply handbrake.
3 Connect the white "Trans Check" single pin connectors together and start the engine.
Note:from this point on, only touch the throttle or brake pedals when directed.
4 Connect the green "Engine Check" single pin connectors for 10 seconds then disconnect. Ignore the "Check EVCT" light if it flashes at this point.
5 Move gear selector into R position.
6 Move gear selector into N position.
7 Move gear selector into D position.
8 Move gear selector into Ds position.
9 Move gear selector back into D position.
10 Ensure the road is clear, release handbrake and accelerate to 50Km/h as fast as possible and hold for at least 5 seconds.
11 Release the throttle and coast to a stop using only the park brake to stop (if necessary).
12 Depress and release the brake pedal three times.
13 Read codes as described in the Code Format Description below.
14 Press the continue button to enter the code numbers and get the code description.
