1 Drive vehicle until it reaches operating temperature.
2 Stop the vehicle, place it in park or neutral and turn ignition OFF.
3 Bridge Black diagnostic socket terminal and earth with a switch as shown in the diagram.
5 Start engine, allow it to idle.
Note -If engine does not start, crank the engine for 6 seconds. Leave ignition ON.
6 Close switch for 5 seconds minimum.
NOTE -Codes can only be retrieved one at a time, to read the next code close switch for 5 seconds.
7 The CEL or LED will begin to flash or the Voltmeter reading will being to change to show codes in the format below.
8 Press the continue button to enter the code numbers and get the code description(s).