Honda ABS - Auto Repair Codes

Scan Tool for Codes and Live Data for your Honda ABS from $199 USD

The information below may apply to Honda CR-V, Odyssey and many other models

Step 4

Honda ABS Code Reading

Connector Diagram

Note: You may need the Rennacs™ UniPlug and UniPlug specific software.
Click here for more info.

Auto Repair Manual - How to read codes (No Special Tools Needed)

Note:If after following the instructions below the ABS light does not flash it either means there are no fault codes or there is a connection error. To test connection, remove a sensor and carefully / safely hoist the car and spin the wheels faster than 30kph with the key on, then recheck codes.

1 Drive the vehicle faster than 30kph for at least 1 minute.

2 Stop vehicle and turn ignition OFF.

3 Connect the terminals with your own wire link, (Click here for details) , as shown on the diagram.

4 Turn ignition ON. If the ABS warning light goes out for 3.6 seconds then comes back on but does not flash there are NO fault codes present

5 If the ABS warning light flashes, read codes as described in the Code Format Description below.

6 Press the continue button to enter the code numbers and get the code description.

Code Format Diagram

Code Format Description

• Code sequence begins with a 2 second flash.

• Each following code is made up of two series of flashes.

• The long flashes indicate the 'tens' digits.

• The short flashes indicate the 'ones' digits.

• A long pause separates each code sequence.

• Once every code has been displayed the code sequence repeats.

• Code Format Diagram shows code No. 12.

To move to the next screen click on the Continue button

 Continue > 

Note on Example Model(s): Honda CR-V, Odyssey
The example model(s) shown, Honda CR-V, Odyssey for this auto repair service are only an indication to help you. There may be many other models that apply to this connector. Click above link to see the complete vehicle coverage list.