Honda ABS

Step 4

Honda ABS Code Reading

Connector Diagram

Tips:

• Connector may be plugged into a retaining socket.

Auto Repair Manual - How to read codes (No Special Tools Needed)

Note:If after following the instructions below the ABS light does not flash it either means there are no fault codes or there is a connection error. To test connection, remove a sensor and carefully / safely hoist the car and spin the wheels faster than 30kph with the key on, then recheck codes.

1 Drive the vehicle faster than 30kph for at least 1 minute.

2 Stop vehicle and turn ignition OFF.

3 Connect the terminals with your own wire link, (Click here for details) , as shown on the diagram.

4 Turn ignition ON. If the ABS warning light stays ON there are NO fault codes present

5 If the ABS warning light flashes, read codes as described in the Code Format Description below.

6 Press the continue button to enter the code numbers and get the code description.

Each code only gets displayed once, to replay codes turn ignition OFF and ON.

Code Format Diagram

Code Format Description

• Code sequence may begin with a 1 second flash.

• Each code is made up of two series of short flashes.

• The first series indicates the 'tens' digit.

• The second series indicates the 'ones' digit.

• A long pause separates each code.

• A shorter pause separates the 'tens' and 'ones'.

• 3 codes can be stored at one time, to replay code sequence turn ignition OFF & ON.

• Code Format Diagram shows code No. 32.

To move to the next screen click on the Continue button

Continue >

Note on Example Model(s): Honda Ascot, Inspire
The example model(s) shown, Honda Ascot, Inspire for this auto repair service are only an indication to help you. There may be many other models that apply to this connector. Click above link to see the complete vehicle coverage list.

Honda ABS - Auto Repair Codes