Ford ABS - Auto Repair Codes

Scan Tool for Codes and Live Data for your Ford ABS from $199 USD

The information below may apply to Ford Fiesta, Raider and many other models

Step 4

Ford ABS Code Reading

Connector Diagram

Auto Repair Manual - How to read codes (No Special Tools Needed)

IMPORTANT:If after you tap 'START' on the next screen it does not show that it is receiving data there are either NO fault codes OR the vehicle not connected properly.

1 Drive the vehicle at 30 kph or more for at least 1 minute.

2 Stop vehicle and turn ignition OFF.

3 Connect an LED tester or Voltmeter to terminals labeled 'A' & 'B', and connect terminals TBS and GND with your own jumper wire as shown in the diagram above. (Click here for details) 

4 Bridge terminals with a wire link as shown in the diagram to your left.

5 Turn ignition ON.

6 Read codes as described in the Code Format Description below.

7 Press the continue button to enter the code numbers and get the code description.

Code Format Diagram

Code Format Description

• Code sequence begins with a 3 second flash.

• Each following code is made up of two series of flashes.

• The long flashes indicate the 'tens' digits.

• The short flashes indicate the 'ones' digits.

• A long pause separates each code sequence.

• Once every code has been displayed the code sequence repeats.

• Code Format Diagram shows code No. 12.

To move to the next screen click on the Continue button

 Continue > 

Note on Example Model(s): Ford Fiesta, Raider
The example model(s) shown, Ford Fiesta, Raider for this auto repair service are only an indication to help you. There may be many other models that apply to this connector. Click above link to see the complete vehicle coverage list.